Teroson Bond 480 (PU 8590) - 600 ml black polyurethane adhesive

Product detailed description

TEROSON PU 8590 - IDH-678730

It is an excellent product due to the following properties:

• Excellent bead stability
• High curing speed
• High curing speed
• aging
• Excellent adhesion to glass, ceramic-coated glass, painted surfaces and primed surfaces
• High UV resistance

ARE OF APPLICATION

TEROSON PU 8 glazing for vehicle bodies (cars, trucks, buses).

• Technology: 1K-polyurethane adhesive free of PVC and solvents
• Product type: Direct glazing for industrial use

black

Odour: slight

Consistency: paste

Specific density: 1.25 g/cm?

Viscosity at 23 °C * 3,000 to 4,500 Pas

Extrusion approx. 300 Powerline )

Solids content 100%

Curing method by air humidity, acceleration possible

Curing speed (5 4 4 4 h

Skin formation (23 °C, 50 % rh) approx. 25 minutes

Shore A hardness approx. 60

Tensile strength approx. 8 MPa

Elongation at break approx. 400%

MPa

Shear strength approx. 5 MPa

Operating temperature range -40 to 90 °C

Recommended application temperature 15 to 50 °C

SURFACE PREPARATION

free from all grease, oil and other contaminants. For cleaning glass, painted and cataphoretically applied coatings (E-coat) use approved cleaners. Henkel Primer should be used in accordance with prior agreement with the Technical Service.

APPLICATION

We recommend the use of fully heated application systems. However, in some cases, partial heating may be sufficient. - All application equipment, including hoses and pipes, must be sealed against moisture. - The floating plate must be driven by a double piston. - The container must be centered. - We recommend switching off the heating when working for more than 1 hour. - The adhesive is dosed from drums or barrels using a high-pressure piston pump with a pneumatic ratio of at least 55:1. Due to the varying conditions of use of the product, we recommend adhering to the data in the currently valid technical data sheet. The application data sheet also contains the necessary information on suitable application equipment and conditions of use. For any further information, please contact your local Henkel technical sales office. It is designed for lifting front, rear and side screens on the bodies of motor vehicles (car, truck, bus).