Loctite SF 734 - 150 ml activator F for acrylic adhesives

Product detailed description

LOCTITE SF 734 (formerly known as LOCTITE 734 - IDH: 142468) is a highly effective, acetone solvent-based liquid activator F designed to accelerate the cure of anaerobic LOCT structural adhesives and sealants. This product is specifically designed for applications on passive metals, inactive surfaces and in situations where there is a large gap between the bonded surfaces.

Key Features

• Increases the cure speed of anaerobic LOCTITE products
and inactive surfaces
• Suitable for wide gap applications
• Fast setting time

Performance Characteristics

• Setting time: ≤12 seconds (tested on microscope coverslip using LOCTITE 312, both sides activated)
• Setting time is defined as the time required to reach a shear strength of 0.1 N/mm&

Directions for use

1. Spray or brush activator onto both surfaces to be bonded. For small joints, it is sufficient to treat only one side.
2. For dirty surfaces, repeated treatment or special degreasing may be necessary.
3. Allow the solvent to evaporate properly in a well-ventilated area until the surface is completely dry.
_x000. Avoid contamination of the treated surface.
4. Apply an anaerobic LOCTITE product to one or both surfaces and bond immediately. glued surfaces to each other for better spreading of the adhesive.
5. Secure the assembly and wait for the fixation time before further manipulation.

Storage

• Classification: HIGHLY FLAMMABLE Store in closed containers in a dry place
• Optimal storage temperature: 8 °C to 21 °C Storage below 8 °C or above 28 °C of the product
• Do not store near oxidizing agents and flammable materials

Safety precautions

Packaging

• Contents: 1
• Catalog number: 19383 IDH: 142468

For assembly, disassembly and cleaning instructions, please refer to the product data sheet. Safety data sheet Loctite SF 734 on request.