Loctite 2700 - 250 ml screw lock VP - BOZP

Product detailed description

Loctite 2700 is a high strength locking agent for maximum effectiveness in locking and sealing screws, nuts and bolts. Prevents loosening caused by vibration. This product is intended for permanent locking of assemblies where loosening is not allowed. It is suitable for all metals including passive materials. It tolerates light contamination. This product is particularly characterised by a safety data sheet without safety and risk phrases. Loctite 2700 carries no hazard symbols, no risk warnings and safety principles and does not contain any substances classified as carcinogenic, mutagenic or toxic to reproduction. Loctite 407 is a clear, thin and fast curing instant adhesive for general use. Particularly suitable for applications where temperature resistance is required. Loctite 407 is particularly suitable for plastics, but also bonds metals very well. It has increased resistance to moisture. Technical parameters: Also available in packages: 20g, 100g and 500g Viscosity: 30 [mPa. s] Maximum joint: 0.10 [mm ] Temperature resistance: - 40 to + 100 [°C] Bonded material: steel, aluminum, zinc dichromate, neoprene, rubber, nitrile, ABS, PVC, polycarbonate, phenol Handling Shear strength [6] ABS after: 6 - 20 On polycarbonate after: 5 - 20 Fixation speed [s]: On steel after: 10 -30 On ABS after: 10 - 30 On polycarbonate after: 20 - 60 Properties: Technology: cyanoacrylate Appearance: transparent, clear to amber low-viscosity Curing: moisture Application: bonding Henkel - Loctite 407 - IDH: 195523 - Catalog number: 40743 Loctite 407 curing instant adhesive is intended for general use - bonding rubber, plastics, metals (steel, aluminum, aluminum). It also bonds neoprene, rubber, ABS, PVC, polycarbonate or phenol without any problems. It is suitable for applications where temperature resistance (up to 100 ° C), moisture resistance, clear bonded joint are required. This product has the best results when bonding in small joints (up to 0.05 mm) due to its low viscosity. Not recommended: use in pure oxygen or oxygen-rich systems and should not be used to seal chlorine or other strongly oxidizing materials. For the best bonding result, the bonded surfaces should be clean and degreased. To accelerate the curing (due to the large joint between the bonded parts), it is recommended to use a suitable Loctite activator. However, this may cause a reduction in the final strength of the bonded joint (test necessary to verify the result). Packaging: 20 g, 100 g, 500 g Properties: Technology: cyanoacrylate Appearance (uncured): transparent, clear to straw yellow liquid Ingredients: one-component Viscosity: low Curing: by moisture Application: bonding Temperature resistance: - 40 to + 1