Alkapren 90 Plus - 1 L adhesive for absorbent surfaces

Product detailed description

Alkaprén® 90 Plus is a rubber toluene-free contact adhesive designed for bonding materials with absorbent surfaces (textiles, plywood, wood, concrete, etc.).

Properties:_x000D

Base: chloroprene rubber, solvent

Color: light beige

Solid content: 24 ± 2 %

Consistency (Ford O 8 mm): 80 to 100 seconds

Thinner: Alkaprén® ZAL Thinner

Consumption: 300 - 400 g/m2

Instructions for use:
Alkaprén® 90 Plus is applied to each material only once, either with a spatula, spray gun or brush. Before application, the adhesive must be thoroughly mixed. A thin layer of adhesive is applied to each clean, degreased material (smooth surfaces are recommended to be roughened), allowed to dry and then both surfaces are glued. It is recommended to load or press the glued joint. The glued joint can be mechanically stressed for up to 24 hours after gluing. The optimal conditions for gluing are at a temperature of 20°C. Gelling may occur at a temperature below 5°C. In this state, the adhesive is unusable. The original consistency is obtained by gradually tempering it in a room at a temperature of approximately 25°C. During tempering, the adhesive must be mixed several times. After tempering, the adhesive has its original physical and mechanical properties. Do not temper it with direct heating! At temperatures below 0°C, the adhesive irreversibly coagulates and it is not possible to revive its adhesive properties.
Cleaning:
Tools are cleaned with Alkaprén® ZAL thinner. If the skin is dirty, use an abrasive paste, e.g. SOLVIT, ...

Packaging:
Cans with a filling of 0.35 kg (500ml), 0.9 kg (1L), 3.6 kg (5L).